Bair Hugger Security Systems Manuel de service télécharger pdf (Page 26)

Bair Hugger Model 750 Temperature Management Unit Service Manual

Check the 3M

Bair Hugger

therapy website to ensure you have the most recent version of this document. www.bairhugger.com reorder #202522A

Replacing the Fuses

Service frequency

As needed.

Caution

Use proper Electrostatic Discharge (ESD) procedures when performing this maintenance. Failure to use

proper ESD preventative measures could cause damage to the control board.

Tools/equipment

• Small Phillips screwdriver

• Medium Phillips screwdriver

• Needle-nose pliers

• ESD strap

• Model 750 Control Board

• Flat screwdriver (optional)

Method

1. Detach the hose (see Detaching Hose on page20 for instructions).

Disassembling the Temperature Management Unit

1. Using a medium Phillips screwdriver, remove the two screws that attach the IV pole clamp or plug.

2. Turn the unit so the bottom of the unit faces up. Remove the four bottom screws with a medium

Phillips screwdriver.

3. Unplug the 2-pin black connector used for the main voltage.

4. Using the medium Phillips screwdriver, remove the two screws that connect the 2 ground wires.

Remove the bottom enclosure.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 36 37

Pas de commentaire

Bair Hugger Security Systems Manuel de service Page 26